General-machine-products 75245 1000 MCM Ratcheting Cable Cutter User Manual download pdf

NEVER use this tool to cut electrically live wire.

Severe or fatal injury may result.

A. Capacity of 2.25¨ for the 1000 MCM cutter and 1.50” diameter

for the 750 MCM cutter. Used to cut copper and aluminum

only. Do not use the tool on steel or ACSR wire.

D. Keep the blades and mechanism clean and oiled. We

recommend CRC SP-350 or an equivalent lubricant.

E. Keep the cutting edges sharp. Treat them as you would a good-

quality knife. Periodically open the blades all the way and hone

them as follows:

l Stone the wiping surface (1) flat near the edge using a flat

India stone or file.

l Stone the 35° angle (2) to remove any nicks.

l Stone very lightly on a 45° angle at (3) to remove any burrs.

B. If you encounter strong cutting resistance, use a one-click

cutting cycle.

C. This tool will not operate unless the fulcrum nut is torqued

to at least 15 lb-ft, so tighten when required.

READ

FIRST!

Important

safety notes

about your

new tool...

GMP #75245 1000 MCM

GMP #75249 750 MCM

General Machine Products

3111 Old Lincoln Hwy.

Trevose, PA 19053

Tel: 215-357-5500

www.gmptools.com

RATCHETING COPPER

OR ALUMINUM

CABLE CUTTER

NEVER use this tool to cut electrically live wire. Severe or fatal injury may result.A. Capacity of 2.25¨ for the 1000 MCM cutter and 1.50” diameter

No comments

General-machine-products 75245 1000 MCM Ratcheting Cable Cutter User Manual